Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
Always work from the side of driver air bag module.

Remove the side lids.
Remove the right and left side TORX bolts (T30).

Fig 1: Removing TORX Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Lift up the driver air bag module.
Disconnect the air bag harness connector, and remove the driver air bag module.
CAUTION:
- For installing / removing driver air bag module connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
Fig 2: Disconnecting Air Bag Harness Connector
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION:

Always work from the side of driver air bag module.
Always place driver air bag module with pad side facing upward.
Do not insert any foreign objects (screwdriver, etc.) into driver air bag module.
Do not disassemble driver air bag module.
Do not use old bolts after removal; replace with new bolts.

Fig 3: Placing Driver Air Bag Module With Pad Side Facing Upward
Courtesy of NISSAN MOTOR CO., U.S.A.
Do not expose the driver air bag module to temperatures exceeding 90°C (194°F).
Replace driver air bag module if it has been dropped or sustained an impact.
Do not allow oil, grease or water to come in contact with the driver air bag module.