Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECTION START
Erase (1st trip) DTCs. Refer to "HOW TO ERASE EMISSION-RELATED DIAGNOSTIC INFORMATION ".
- : GO TO 2.
- CHECK GROUND TERMINALS
Check ground terminals for corroding or loose connection.
Refer to "HOW TO PERFORM EFFICIENT DIAGNOSIS FOR AN ELECTRICAL INCIDENT ".
OK or NG
- OK : GO TO 3.
- NG : Repair or replace.
- SEARCH FOR ELECTRICAL INCIDENT
Perform "HOW TO PERFORM EFFICIENT DIAGNOSIS FOR AN ELECTRICAL INCIDENT ".
OK or NG
- OK : GO TO 4.
- NG : Repair or replace.
- CHECK CONNECTOR TERMINALS
Refer to "HOW TO CHECK TERMINAL ".
OK or NG
- OK : INSPECTION END
- NG : Repair or replace connector.