Inspection Procedure
WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- DISPLAY SELF DIAGNOSIS RESULTS
Check self-diagnosis results.
SELF-DIAGNOSIS RESULTS CHARTSelf-diagnosis results DELTA S SEN NG Is the above displayed in the self-diagnosis display items?
YES or NO
- YES: GO TO 2.
- NO: Inspection End.
- CONNECTOR INSPECTION
- Turn the ignition switch OFF.
- Disconnect the delta stroke sensor connector E114 and ABS actuator and electric unit (control unit) connector E125 and inspect the terminals for deformation, disconnection, looseness, or damage.
OK or NG
- OK: GO TO 3.
- NG: Repair connector.
- DELTA STROKE SENSOR CIRCUIT INSPECTION
- Measure the continuity between the ABS actuator and electric unit (control unit) connector E125 and delta stroke sensor connector E114.TERMINALS CONTINUITY CHART
ABS actuator and electric unit (control unit) connector E125 Delta stroke sensor connector E114 Continuity 26 (W/V) 1 (W/V) Yes 39 (G/B) 3 (G/B) 40 (R/Y) 5 (R/Y) - Measure the continuity between the ABS actuator and electric unit (control unit) connector E125 and body ground.TERMINALS CONTINUITY CHART
ABS actuator and electric unit (control unit) connector E125 Body ground Continuity 26 (W/V) - No 39 (G/B) 40 (R/Y)
OK or NG
- OK: GO TO 4.
- NG: Repair or replace harness or connector.
- Measure the continuity between the ABS actuator and electric unit (control unit) connector E125 and delta stroke sensor connector E114.
- DELTA STROKE SENSOR INSPECTION
- Reconnect the delta stroke sensor and ABS actuator and electric unit (control unit) connectors.
- Use "DATA MONITOR" to check if the status of "DELTA S SEN" is normal.DATA MONITOR REFERENCE CHART
Condition Data monitor display (Approx.) DELTA S SEN When brake pedal is released 0.00 mm (+0.6/-0.4) When brake pedal is depressed 1.05-1.80 mm
OK or NG
- OK: Inspection End.
- NG: Replace delta stroke sensor. Refer to WITH ABS OR BLSD .