LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Rogue S, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0130 To P0340 - For CALIFORNIA >> DTC P0340: CMP Sensor (Phase) >> Diagnosis Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Diagnosis Procedure

  1. CHECK STARTING SYSTEM

    Turn ignition switch to START position.

    Does the engine turn over? Does the starter motor operate? 

    YES: Go to 2.

    NO: Check starting system.

  2. CHECK GROUND CONNECTION
    1. Turn ignition switch OFF.
    2. Check ground connection E21. Refer to Ground Inspection in " CIRCUIT INSPECTION ".

    Is the inspection result normal? 

    YES: Go to 3.

    NO: Repair or replace ground connection.

  3. CHECK CAMSHAFT POSITION (CMP) SENSOR (PHASE) POWER SUPPLY CIRCUIT
    1. Disconnect camshaft position (CMP) sensor (PHASE) harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between CMP sensor (PHASE) harness connector and ground.
    VOLTAGE REFERENCE CHART

    CMP sensor (PHASE) Ground Voltage
    Connector Terminal
    F26 1 Ground Approx. 5 V

    Is the inspection result normal? 

    YES: Go to 4.

    NO: Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK CMP SENSOR (PHASE) GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Check the continuity between CMP sensor (PHASE) harness connector and ECM harness connector.
      CONTINUITY REFERENCE CHART

      CMP sensor (PHASE) ECM Continuity
      Connector Terminal Connector Terminal
      F26 2 F8 64 Existed
    3. Also check harness for short to power.

    Is the inspection result normal? 

    YES: Go to 5.

    NO: Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK CMP SENSOR (PHASE) INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Disconnect ECM harness connector.
    2. Check the continuity between CMP sensor (PHASE) harness connector and ECM harness connector.
      CONTINUITY REFERENCE CHART

      CMP sensor (PHASE) ECM Continuity
      Connector Terminal Connector Terminal
      F26 3 F8 69 Existed
    3. Also check harness for short to ground and short to power.

    Is the inspection result normal? 

    YES: Go to 6.

    NO: Repair open circuit or short to ground or short to power in harness or connectors.

  6. CHECK CAMSHAFT POSITION SENSOR (PHASE)

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Go to 7.

    NO: Replace camshaft position sensor (PHASE). Refer to " EXPLODED VIEW ".

  7. CHECK CAMSHAFT (INT)

    Check the following.

    • Accumulation of debris to the signal plate of camshaft (1) rear end
    • Chipping signal plate of camshaft rear end

    Is the inspection result normal? 

    YES: Go to 8.

    NO: Remove debris and clean the signal plate of camshaft rear end or replace camshaft Refer to " REMOVAL AND INSTALLATION ".

    Fig 1: Inspecting Debris To Signal Plate Of Camshaft Rear End
    G04886800Courtesy of NISSAN MOTOR CO., U.S.A.
  8. CHECK INTERMITTENT INCIDENT

    Refer to " INTERMITTENT INCIDENT ".

    INSPECTION END

scientia non olet · About LEMON Manuals