LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2016 >> Sentra FE+S >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTCS) (2 Of 3) >> DTC/Circuit Diagnosis >> DTC P0500: VSS >> Except For M/T Models >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine.
    2. Shift the selector lever to D range and wait at least for 2 seconds.
    3. Drive the vehicle at least 10 seconds at 20 km/h (13 MPH) or more.
      CAUTION:

      Always drive vehicle at a safe speed.

      NOTE:

      This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

    4. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE 

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals