Diagnosis Mode
CONSULT
- Confirm that zero point reset of OCS is complete.
- If no DTCs are detected on "SELF-DIAG RESULTS [CURRENT]", repair of SRS is completed. Go to step 3.
If any DTCs are detected on "SELF-DIAG RESULTS [CURRENT]", the malfunction has not been repaired completely or another malfunction is being detected. Perform SRS Operation Check again. Refer to On Board Diagnosis Function .
- Select "ERASE".NOTE: Selecting "ERASE" will clear the SRS memory of the malfunction ("SELF-DIAG [PAST]"). If "SELF-DIAG [PAST]" is not erased, User Mode may show the previous system malfunction even if the malfunction has been repaired completely.
- Check that no malfunction is detected in "SELF-DIAG [PAST]".
- Exit Diagnosis Mode and disconnect the CONSULT.
- Perform SRS Operation Check. Refer to On Board Diagnosis Function .