Work Procedure

SAVING VEHICLE SPECIFICATION
1. CONSULT
  Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to Description .
  
  NOTE: If "READ CONFIGURATION" can not be used, use "MANUAL CONFIGURATION" after replacing around view monitor control unit.
>>

GO TO 2.
REPLACE AROUND VIEW MONITOR CONTROL UNIT
1. Replace around view monitor control unit. Refer to Removal and Installation .
>>

GO TO 3.
WRITING VEHICLE SPECIFICATION
1. CONSULT Perform "WRITE CONFIGURATION - Config file" or "MANUAL CONFIGURATION" to write vehicle specification. Refer to Work Procedure .
>>

GO TO 4.
CALIBRATE CAMERA IMAGE
1. Perform calibration of camera image. Refer to Description .
>>

Work End.