Removal & Installation (2.2L, 2.5L & 3.1L)
- Disconnect negative battery cable. Unplug connectors at ignition module. Disconnect spark plug wires from coil pack. Remove ignition module from engine block. Remove coils and assembly plate.
- On 2.5L engines, inspect crankshaft sensor "O" ring for wear, cracks or other damage. Replace if necessary. Lubricate new "O" ring with engine oil before installing.
- To install, reverse removal procedure. Tighten ignition coil nuts and module to specification. See TORQUE SPECIFICATIONS at the end of article.
NOTE:
If spark plug boots adheres to spark plugs, use Boot Remover (J-36011). Twist first and then pull upward. Boots must be in place on housing prior to ignition system assembly installation or damage may result.