Transmission Position Sensor/Switch: Service and Repair

REMOVAL

1. Disconnect negative battery cable.
2. Disconnect shift linkage.
3. Disconnect electrical connector.
4. Remove mounting bolts.
5. Remove switch assembly.

INSTALLATION

1. Place shift shaft in "Neutral."
2. Align flats of shift shaft with switch.
3. Install mounting bolts, loosely.
4. Insert gage pin in service adjustment hole and rotate switch until pin drops in to a depth of 9.0 mm (9/64").
5. Tighten bolts to 24 N-m (18 lbs.ft.).