LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 1996 >> Eighty-Eight Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls - Remove/Install/Overhaul 3.8L) >> Ignition System >> Ignition Control Module (C(3)I) >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different car, the 1996 Oldsmobile Ninety-Eight and 1996 Buick Park Avenue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Disconnect 14-way connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Tilt coil assembly back, and disconnect connectors between ignition coil and module. Remove coil pack.
  2. Remove nuts and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws and nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals