Powertrain Control Module (Pcm): Notes
WARNING: This page is about a different car, the 1998 Pontiac Bonneville, 1998 Oldsmobile Regency, 1998 Oldsmobile LSS, 1998 Oldsmobile Eighty-Eight, and 1998 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Electronic components used in control systems are designed to carry very low voltages. As little as a 30-volt charge created by static electricity can cause a total or degrading failure in PCM or other electronic components containing integrated circuits. Before servicing PCM, technician must ground himself and the work area to discharge static electricity.
CAUTION:
DO NOT remove part from packaging until ready to install. Ground any static-proof package before opening. DO NOT touch electrical terminals of components unless properly grounded. DO NOT lay electrical components on car seat, carpeting or dashboard. Use electrostatic protection mat and ground strap whenever possible.
NOTE:
Before replacing PCM, carefully inspect all wiring and control components. Failure to test for short circuits may result in repeated PCM failure due to shorts. To prevent internal damage to PCM, ensure ignition switch is in OFF position when connecting or disconnecting PCM connectors or any electrical components.