Electronic Brake Control Module (EBCM) Or Electronic Brake Traction Control Module (EBTCM): Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1999 Pontiac Grand Prix, 1999 Pontiac Firebird, 1999 Oldsmobile Intrigue, 1999 Chevrolet Camaro, and 1998 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- To install, clean BPMV gasket surface with alcohol. Install NEW wave spring(s) in original location and position between EBCM/EBTCM and BPMV. Install EBCM/EBTCM to BPMV. Install NEW top mounting screws and tighten in an "X" pattern to 26 INCH lbs. (2.9 N.m). Install 2 NEW bottom screws and tighten to 26 INCH lbs. (2.9 N.m).
- Connect pump motor connector at bottom of EBCM/EBTCM. Connect EBCM/EBTCM harness connector and push in lock tab. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.