Electronic Brake Traction Control Module (EBTCM): Installation

To install, clean BPMV gasket surface with alcohol. Install NEW wave spring(s) in original location and position between EBTCM and BPMV. Install EBTCM to BPMV. Install 4 NEW top mounting screws and tighten in an "X" pattern. Install 2 NEW bottom screws and tighten. See TORQUE SPECIFICATIONS .
Connect pump motor connector at bottom of EBTCM. Connect EBTCM harness connector and push in lock tab. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.