Electronic Brake Control Module: Removal

WARNING: This page is about a different car, the 2001 Pontiac Grand Prix, 2001 Pontiac Firebird, 2001 Oldsmobile Intrigue, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

EBCM is mounted on top of left front frame rail (Camaro and Firebird) or on left side strut tower in engine compartment (Grand Prix and Intrigue). Disconnect negative battery cable. Turn ignition switch to OFF position. Pull out lock tab from EBCM harness connector and disconnect connector. Disconnect pump motor connector from bottom of EBCM.
Remove and discard 6 EBCM-to-Brake Pressure Modulator Valve (BPMV) screws. Using care so as not to damage seal and solenoid valves, pull EBCM and separate from BPMV. Note location and position of wave spring(s) between EBCM and BPMV. Remove and discard wave spring(s).