Specifications Index
BLAZER, S10, BRAVADA, JIMMY & SONOMA SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning - Automatic System (Blazer, Bravada, & Jimmy) | |||
| Service | SPECIFICATIONS | ||
| Torque | NA | ||
| Air Conditioning - Manual System (Blazer, Jimmy, Sonoma & S10 Pickup) | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| AWD/4WD | 103 Ft. Lbs. (140 N.m) | ||
| Battery | BATTERY TESTING & INSPECTION | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF Also see BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | See appropriate illustration under SERPENTINE BELT ROUTING & ALIGNMENT | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 15 psi | ||
| Thermostat R& I | N/A | ||
| Water Pump R & I | |||
| 4.3 L | WATER PUMP REMOVAL , WATER PUMP INSTALLATION | ||
| 2.2 L | WATER PUMP | ||
| Engine Mechanical | |||
| 4.3L | |||
| Compression | Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 100 psi (7 kg/cm2 ). | ||
| Oil Pressure Minimum - at Normal Operating Temperature |
6 psig (42kPa) at 1,000 RPM 18 psig (125 kPa) at 2,000 RPM 24 psig (166 kPa) at 4,000 RPM |
||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 2.2L | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Normal oil pressure is 56 psi (3.9 kg/cm2 ) at 3000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | |||
| 4.3 L | 74 Ft. Lbs. (100 N.m) for tightening sequence, see appropriate illustration under TORQUE SPECIFICATIONS |
||
| 2.2 L | 55 Ft. Lbs. ((75 N.m) Apply thread locking compound to bolts |
||
| Fuel System | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | |||
| 4.3 L | See appropriate illustration under FIRING ORDER | ||
| 2.2 L | NA | ||
| Spark Plug | |||
| Type | |||
| 4.3 L | AC R41-932 | ||
| 2.2 L | AC 41-948 | ||
| Gap | |||
| 4.3 L | .060 In. (1.52 mm) | ||
| 2.2 L | 0.40 In. (1.02 mm) | ||
| Torque | |||
| 4.3L | 11 Ft. Lbs. (15 N.m) | ||
| 2.2 L | 13 Ft. Lbs. (18 N.m) | ||
| Starting | |||
| Starter | SYSTEM TESTS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 92 Ft. Lbs. (125 N.m) | ||