Powertrain Control Module: Installation
NOTE:
The following areas must be inspected before installing the PCM. Ensure there is no debris in the air filter/PCM housing assembly, or in the MAF/IAT sensor inlet screen that may distort the air flow. Ensure there are no signs of damage to the air filter/PCM housing assembly, or to the intake air duct. If a problem is found, replace the component as necessary.
- Install the PCM. Install the PCM connectors. Tighten the PCM connectors screws to specification. See TORQUE SPECIFICATIONS . Install the intake air duct, the MAF/IAT sensor, and the air filter housing cover to the throttle body.
- Ensure the intake air duct is installed properly on the throttle body. An improperly installed or distorted damaged air filter, or intake air duct may cause a DTC to set. Align and engage the tabs on the air filter housing cover with the slots in the air filter/PCM housing.
- Tighten the air filter housing cover screws to specification. Tighten the intake air duct clamp at the throttle body. Reconnect the MAF/IAT sensor connector. Connect the negative battery cable. Install the rear seat cushion.