LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1750 (Navigation Systems) >> Diagnostic Information and Procedures >> DTC B2462: Global Positioning System (GPS) Signal Error >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 1:  Determines if the malfunction is present.
  2. 3:  Determines if the malfunction is due to an internal fault in the navigation radio or a GPS antenna failure.
DTC B2462

Step Action Value(s) Yes No
Schematic Reference:  Navigation System Schematics  
Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Turn OFF the ignition.
  2. Disconnect the global positioning system (GPS) coaxial cable connector.
  3. Measure the voltage between the center conductor and the shield of the coaxial cable still attached to the navigation radio.
Is the voltage within the specified range?
4.0-5.5 V Go to Step 5  Go to Step 3 
Test the GPS cable for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 7  Go to Step 4 
4 Inspect for poor connections at the harness connector of the GPS cable. Refer to Testing for Intermittent Conditions and Poor Connections andConnector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 7  Go to Step 6 
5 Replace the GPS antenna. Refer to Antenna Replacement - Global Positioning System (GPS) (Module Assembly Radio Antenna) .
Did you complete the replacement?
- Go to Step 7  -
6 Replace the navigation radio. Refer to Control Module References in Computer/Integrating Systems.
Did you complete the replacement?
- Go to Step 7  -
7
  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK