Ignition System: Overhaul: Disassembly: Notes

Mazda GLC

1) Remove distributor cap and rotor. Remove reluctor and retaining pin. Remove pick-up coil. Remove vacuum control unit mounting screw and disconnect lever from breaker plate pin.

2) Remove breaker plate assembly. Remove governor cam, springs and weights. Remove clip from bottom of distributor shaft. Remove distributor shaft from housing. Keep washers in order for reassembly in original locations.

Chrysler Corp.

1) Remove distributor cap, rotor and seal. Remove governor assembly. Remove vacuum control unit. Remove IC ignitor. Remove lead wire. Remove signal rotor shaft screw and 2 breaker plate retaining screws. Remove breaker plate assembly.

1. Remove signal rotor shaft from signal rotor. Remove 2 spring retainers and springs with pliers. Remove governor weights. Mark drive gear location on distributor shaft.
2. Place drive gear on a wooden block and remove drive gear roll pin using a pin punch. Remove drive gear and washer. Remove distributor shaft from housing.