LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1992 >> Voyager Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L >> DRB-II Test Functions >> Fuel/IGN Menu >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel/IGN Menu: Notes

NOTE: DO NOT  touch DRB-II keypad during DRB-II power-up sequence or an error message will result.
  1. In order to perform self-diagnostic tests using DRB-II, DRB-II must be in the FUEL/IGN MENU. At the FUEL/IGN MENU, fault codes and DRB-II test functions can be accessed.
  2. To reach FUEL/IGN MENU, turn ignition off. Connect DRB-II to engine diagnostic connector, located in engine compartment, near SBEC on all models except Dakota. On Dakota models, diagnostic connector is located in right rear corner of engine compartment, taped to harness. Turn ignition switch to RUN position.
  3. All DRB-II character positions will glow and copyright information will appear on screen for a few seconds. If screen is blank or any error messages appear, see DRB-II PROBLEMS & ERROR MESSAGES  .
  4. After a few seconds, DRB-II menu will appear. At DRB-II menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. DRB-II screen will indicate engine year, size, type of transmission and SBEC part number.
  5. After a few seconds, AIR COND menu will appear. Press "1" (WITH A/C) or "2" (WITHOUT A/C). DRB-II display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "1" (FUEL/IGNITION) key. Press ENTER key.
  6. Display will change to FUEL/IGN MENU. At FUEL/IGN MENU of engine diagnostic program, specific test functions programmed into DRB-II can be performed. The following DRB-II modes can be accessed: SYSTEM TESTS, READ FAULTS, STATE DISPLAY, ACTUATOR TESTS and ADJUSTMENTS.