Test TC-15B - Speed Control Solenoid Circuits
NOTE:
Perform TEST TC-15A before proceeding. For connector terminal IDENTIFICATION, see CONNECTOR IDENTIFICATION DIRECTORY. For wiring diagram, see WIRING DIAGRAMS - 2.4L
article.
- Using ohmmeter, check resistance between terminal No. 4 (Dark Blue/Red wire) on connector for brake switch and terminal No. 3 (Dark Blue/Red wire) on connector for speed control servo.
- If resistance is less than 5 ohms, replace brake switch. Perform TEST VER-4A. If resistance is 5 ohms or more, repair open circuit in Dark Blue/Red wire between brake switch and speed control servo. Perform TEST VER-4A.