Electronic Brake Control Module (EBCM) Or Electronic Brake Traction Control Module (EBTCM): Installation
- To install, clean BPMV gasket surface with alcohol. Install NEW wave spring(s) in original location and position between EBCM/EBTCM and BPMV. Install EBCM/EBTCM to BPMV. Install NEW top mounting screws and tighten in an "X" pattern to 26 INCH lbs. (2.9 N.m). Install 2 NEW bottom screws and tighten to 26 INCH lbs. (2.9 N.m).
- Connect pump motor connector at bottom of EBCM/EBTCM. Connect EBCM/EBTCM harness connector and push in lock tab. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.