Pull-In Windings Test
Connect test equipment as in hold-in windings test. See HOLD-IN WINDINGS TEST . See Figure. Ground starter solenoid terminal "M". Turn switch on and quickly adjust carbon pile load until voltage reads as specified. See PULL-IN WINDINGS SPECIFICATIONS table. Check ammeter reading. Turn off carbon pile and open switch. See PULL-IN WINDINGS SPECIFICATIONS table. If ammeter reading is not as specified, replace starter assembly.
PULL-IN WINDINGS SPECIFICATIONS
| Application | Starter Motor | Amps @ Volts | |||
|---|---|---|---|---|---|
| 2.2L | PG260 | (1) | |||
| 2.4L | PG260, PG260MQ | (1) | |||
| 3.0L | (1) | (1) | |||
| 3.1L | |||||
| "N" Body | PG260F1 | (1) | |||
| "W" Body | PG260F1 | 30-45 @ 10 | |||
| 3.4L | PG260M1 | (1) | |||
| 3.5L | PG260M1 | 30-45 @ 10 | |||
| 3.8L | |||||
| "C", "F" & "H" Body | PG260 | 30-50 @ 11.5 | |||
| "G" Body | (1) | 30-50 @ 11.5 | |||
| "W" Body | PG260F2, PG260M | 30-45 @ 10 | |||
| 4.0L | (1) | 30-50 @ 11.5 | |||
| 4.6L | PG260 | 30-50 @ 11.5 | |||
| 5.7L | PG260 | 30-50 @ 11.5 | |||
|
|||||