10 Minute Learn Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure requires a Tech 2 scan tool and a Techline terminal with current SPS (Service Programming System) software.
- Connect the Tech 2 to the vehicle.
- Select "Request Information" under "Service Programming".
- Disconnect the Tech 2 from the vehicle and connect it to a techline terminal.
- On the techline terminal, select "Theft Module Re-Learn" under "Service Programming".
- Disconnect the Tech 2 from the techline terminal and connect it to the vehicle.
- Turn ON the ignition, with the engine OFF.
- Select "VTD Re-Learn" under "Service Programming".
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF (the vehicle is now ready to relearn the Passlock(tm) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK).
- Turn OFF the ignition, and wait 5 seconds.
- Start the engine (the vehicle has now learned the password).
- With the Tech 2 (scan tool), clear any DTCs.