LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System Self-Diagnostics - 3.1L Engine) >> Diagnostic Tests >> DTC P1670: Output Driver Module No. 4 >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Malibu, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Is DTC P0560 set? If yes, diagnose engine electrical system. See appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS. If no, go to next step.
  3. With a scan tool select the Output Driver Data list. Observe the parameters on the scan tool. Do any parameters indicate a fault present? If yes, go to next step. If no, go to step  5.
  4. Test for a short to voltage on the circuit to the component that indicated a fault. Did you find and correct the condition? If yes, go to step  6. If no, go to next step.
  5. Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After replacing PCM, go to next step.
  6. Use scan tool to clear DTCs. Turn ignition off for 30 seconds. Start engine. Operate the vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  7. Using scan tool, observe stored information and Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals