LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 914 (Cellular Communication System) >> Repair Instructions >> Communication Interface Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.
  1. Remove the Instrument Panel (I/P) upper trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
  2. Fully open the I/P storage compartment.
  3. Disconnect the electrical connectors (2) from the Vehicle Communication Interface module (VCIM) (1).
    Fig 1: Vehicle Communication Interface Module (VCIM)
    GM854863Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the coaxial cable (3) from the VCIM.
    5. Fig 2: Locating Passenger Side Upper I/P Support
    GM1260587Courtesy of GENERAL MOTORS CORP.
  5. Remove the screws (1, 3) from the passenger side upper I/P support (2).
  6. Remove the passenger side upper I/P support (2).
    7. Fig 3: Removing Screw (1) Retaining The VCIM Bracket To The I/P
    GM1260499Courtesy of GENERAL MOTORS CORP.
  7. Remove the screw (1) retaining the VCIM bracket to the I/P.
  8. Remove the retainer from the VCIM bracket.
  9. Remove the nuts holding the mounting brackets to the VCIM.
  10. If necessary, move the cross-car duct forward slightly in order to make room for the removal of the module.
    11. Fig 4: Removing The Vcim And Bracket Assembly
    GM1260503Courtesy of GENERAL MOTORS CORP.
  11. Remove the VCIM and bracket assembly from the I/P.
    12. Fig 5: Removing Nuts (4) From The VCIM Mounting Brackets
    GM1260485Courtesy of GENERAL MOTORS CORP.
  12. Remove the nuts (4) from the VCIM mounting brackets (2).
  13. Remove the mounting brackets (2) from the VCIM (1).
scientia non olet · About LEMON Manuals