LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 945 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the ignition control module (2) and heat sink (3).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install ignition control module (2) screws.

    Tighten:  Tighten the screws to 3.5 N.m (31 lb in).

  3. Connect the ignition coil driver electrical connector (3).
    4. Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals