Test Description
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: Verify that the DTC is current or history by monitoring the switch status for which the code is set.
- 3: Tests the memory select switch for an internal fault.
DTC B2755 or B2760
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Seat Schematics Connector End View Reference: Power Seat Systems Connector End Views |
|||
| 1 | Did you perform the Power Seat System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Power Seat Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Test the switch signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 5 | Inspect and repair any damage to the memory select switch connector and terminals which may cause the condition. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect and repair any damage to the memory seat module connector and terminals which may cause the condition. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the memory select switch. Refer to Memory Seat Switch Replacement (Rendezvous) . Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the memory seat module. Refer to Memory Seat Control Module Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 9 |
|
Go to Step 2 | System OK |