LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Engine Controls Self-Diagnostics - 4.3L) >> Inspection/Maintenance Procedures >> Inspection/Maintenance System Check >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection/Maintenance System Check: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Sonoma, 2002 GMC Safari, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Many DTC related repairs will instruct the technician to clear the DTC information. This procedure will reset ALL of the I/M System Status indicators to NO, and require performing the I/M Complete System Set Procedure.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. Repair any DTCs or driveability concerns that would prevent the I/M System Status tests from completing. Did you find and repair a DTC or driveability concern? If yes, go to step  3. If no, go to next step.
  2. Review any service bulletins for software updates that may prevent I/M readiness. Perform any reprogramming or repairs indicated by the service bulletins. Was a reprogramming or repair service required? If yes, see INSPECTION/MAINTENANCE COMPLETE SYSTEM SET PROCEDURE . If no, go to next step.
  3. With a scan tool, observe the I/M System Status display. Is more than one test indicating a NO status? If yes, see INSPECTION/MAINTENANCE COMPLETE SYSTEM SET PROCEDURE . If no, go to the I/M System Set Procedure for the indicated system.
scientia non olet · About LEMON Manuals