LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 434 (Exterior Trim) >> Repair Instructions >> Cladding Replacement -Rear Lower P/U Box (Xtreme) >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cladding to the pickup box.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the nuts that retain the cladding to the pickup box.

    Tighten 

    Tighten the nuts to 2 N.m (18 lb in).

  3. Install the push-pin.
  4. Lower the vehicle.
    Fig 1: Installing Cladding To Pickup Box Retaining Nut
    G01477351Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals