LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2003 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Controls - Self-Diagnostics - 2.2L) >> Drive Cycles >> Inspection/Maintenance System Check >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For the specific DTCs required for each system, refer to INSPECTION/MAINTENANCE SYSTEM DTCS . Systems such as fuel delivery, misfire, and comprehensive components may not be listed in a system status list. These tests run continuously and do not require an I/M System Status indicator.
    NOTE: Many DTC related repairs will instruct the technician to clear the DTC information. This procedure will reset ALL of the I/M System Status indicators to NO, and require performing the I/M Complete System Set Procedure.
  1. Perform powertrain diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. Repair any DTCs or driveability concerns that would prevent the I/M System Status tests from completing. Did you find and repair a DTC or driveability concern? If yes, go to step  3. If no, go to next step.
  2. Review any service bulletins for software updates that may prevent I/M readiness. Perform any reprogramming or repairs indicated by the service bulletins. Was a repair service required? If yes, go to INSPECTION/MAINTENANCE COMPLETE SYSTEM SET PROCEDURE . If no, go next step.
  3. Using scan tool, observe the I/M System Status display. Is more than one test indicating a NO status? If yes, go to INSPECTION/MAINTENANCE COMPLETE SYSTEM SET PROCEDURE . If no, go to appropriate INSPECTION/MAINTENANCE SYSTEM SET procedure for the indicated system.
scientia non olet · About LEMON Manuals