Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Shock Module Upper Retaining Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the shock module upper retaining nuts.

NOTE: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheels.
Remove the shock module yoke to lower control arm retaining nut.

Fig 2: Removing/Installing Shock Module Yoke Lower Mounting Nut
Courtesy of GENERAL MOTORS CORP.

Fig 3: Disconnecting Shock Module Yoke From Lower Control Arm

Courtesy of GENERAL MOTORS CORP.

Remove the shock module yoke from the lower control arm using J 24319-B .

Fig 4: Removing/Installing Shock Module

Courtesy of GENERAL MOTORS CORP.

Remove the shock module from the shock tower and lower control arm.