Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the new fuel tank pressure sensor (7) to the fuel sender assembly (1).

Fig 1: Fuel Pump & Sender Assembly Component View

Courtesy of GENERAL MOTORS CORP.

Connect the fuel tank pressure sensor electrical connector.
Install the fuel sender access panel.

Fig 2: Fuel Sender Access Panel

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the fuel sender access panel nuts.
Tighten: Tighten the nuts to 10 N.m (89 lb in).
Install the rear compartment trim panel. Refer to Floor Trim Plate Replacement - Rear in Body Rear End.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.