Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the MAF/IAT sensor to the air cleaner assembly, if necessary.
- Install a new clamp using the J 22610 . See Special Tools and Equipment .
- Position the air intake duct to the throttle body. Ensure the air intake duct grommets are secure on the studs.
- Tighten the air intake duct clamp at the throttle body.
- Use a GM approved non-silicone lubricant in order to help with installation. Position the air cleaner assembly with mounting grommets to the mounting studs.
- Secure the air cleaner assembly to the mounting studs.
- Connect the AIR hose to the air cleaner assembly.
- Connect the MAF/IAT sensor electrical connector.
NOTE:
Verify that the radiator air deflector is in position before installing an air cleaner assembly. Improper installation may allow water intrusion which could damage the engine.
NOTE:
If the mass air flow (MAF) sensor is installed backwards, the system will go rich. An arrow cast into the plastic portion of the sensor indicates proper air flow direction. The arrow must point toward the engine.