Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radiator Upper Support & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the radiator support.

Fig 2: Installing Radiator Support

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the radiator support bolts.
Tighten: Tighten the bolts to 8 N.m (71 lb in).

Fig 3: Air Cleaner Intake Duct

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Seat the air cleaner retaining grommets fully. If necessary moisten the grommets with water prior to installation.

Install the air cleaner intake duct.

Fig 4: Mass Air Flow Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the engine wiring harness to the clip on the radiator support.
Connect the mass air flow sensor electrical connector.