LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2004 >> Aztek Rally, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower control arm to the steering knuckle.
    2. IMPORTANT: Take care not to disengage the axle shaft from the transmission.
    Fig 1: Removing/Installing Lower Control Arm-To-Lower Control Arm Bracket Mounting Nuts
    GM744325Courtesy of GENERAL MOTORS CORP.
  2. Pivot the lower control arm outward and upward in order to connect the lower control arm to the lower control arm bracket.
  3. Install the lower control arm to the lower control arm bracket.
  4. Install the lower control arm to lower control arm bracket mounting bolts.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Ensure that the lower control arm is parallel to the lower control arm bracket during the installation and tightening of the lower control arm mounting bolts and nuts. This will ensure correct alignment of the lower control arm bushings.
  5. Install the lower control arm to lower control arm bracket mounting nuts.

    Tighten:  Tighten the nuts to 110 N.m (81 lb ft).

  6. Connect the shock module yoke to the lower control arm.
    Fig 2: Removing/Installing Shock Module Yoke Lower Mounting Nut
    GM744328Courtesy of GENERAL MOTORS CORP.
  7. Install the shock module yoke lower mounting nut.
    8. IMPORTANT: There is a washer between the stabilizer shaft link and the lower control arm made of hardened steel and has a felt inner liner. Only replace this washer with an identical washer, standard washers should not be used.
    Fig 3: View Of Stabilizer Shaft Link Lower Retaining Nut
    GM731562Courtesy of GENERAL MOTORS CORP.
  8. Install the stabilizer shaft link and washer to the lower control arm.
  9. Install the stabilizer shaft link retaining nut.

    Tighten:  Tighten the nut to 145 N.m (107 lb ft).

    10. Fig 4: Removing/Installing Tie Rod
    GM687435Courtesy of GENERAL MOTORS CORP.
  10. Install the outer tie rod to the steering knuckle.
  11. Install the outer tie rod retaining nut.

    Tighten:  Tighten the nuts to 45 N.m (33 lb ft).

  12. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  13. Lower the vehicle.
  14. Inspect the front wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.
scientia non olet · About LEMON Manuals