LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Boost Control Solenoid Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the boost control solenoid (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the boost control solenoid nut.

    Tighten:  Tighten the nut to 8 N.m (71 lb in).

  3. Connect the boost control solenoid electrical connector.
  4. Connect the boost source and signal hoses to the boost control solenoid (2).
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
    6. Fig 1: Installing Boost Control Solenoid
    GM66407Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals