Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the TP sensor to the throttle body assembly.
Apply thread-locking compound GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the TP sensor screws.

Fig 1: Installig TP Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 TP sensor screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Installing TP Sensor Screws

Courtesy of GENERAL MOTORS CORP.

Connect the TP sensor electrical connector.
Install the fuel injector sight shield. Refer toFuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.

Fig 3: Connecting TP Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.