LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition coils (2) to the ICM (3).
    2. Fig 1: View Of Ignition Coil Module And Module Mounting Bracket
    GM12299Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil screws (1).

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Install the ICM (1) to the bracket.
  4. Install the ICM nuts (2).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    5. Fig 2: View Of ICM & Bracket
    GM911107Courtesy of GENERAL MOTORS CORP.
  5. Connect the spark plug wires to the ignition coils.
  6. Install the 14-way electrical connector to the ICM.

    Tighten:  Tighten the screw to 2.1 N.m (19 lb in).

scientia non olet · About LEMON Manuals