LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

  1. Install the controls and the control harness to the steering wheel.
    2. Fig 1: Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  2. Install the wiring through the steering wheel.
  3. Install the steering wheel.
  4. Connect the steering wheel control electrical connector.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the steering wheel nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Aztek) or Inflatable Restraint Steering Wheel Module Replacement (Rendezvous) in SIR.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
scientia non olet · About LEMON Manuals