LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System 3.4L (Introduction)) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the air cleaner element (6) to the air cleaner assembly (1).
  2. Install the air cleaner cover (5) with the air cleaner intake duct.
  3. Install the 2 air cleaner cover clips.
    4. Fig 1: Installing Air Cleaner Element
    GM444460Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner intake duct to the throttle body.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the air cleaner intake duct clamp (2).

    Tighten:  Tighten the clamp to 2 N.m (18 lb in).

  6. Connect the MAF sensor electrical connector (5).
  7. Install the PCV tube (4) to the air cleaner intake duct.
  8. Connect the IAT sensor electrical connector (3).
    9. Fig 2: Installing Air Cleaner Intake Duct
    GM811623Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals