Torque Sensor Calibration
- Install the scan tool.
- Turn ON the ignition, with the engine OFF.
- Center the steering wheel.
- With the scan tool select Special Functions.
- Select Torque Sensor Calibration and press the Enter key. The scan tool screen will flash Calibration in Progress.
- When done, the scan tool will display Calibration Complete.
- Press the exit key
- Use the scan tool in order to clear the DTCs
- Turn OFF the ignition.
IMPORTANT:
After centering the steering wheel, remove hands and other objects from the steering wheel and ensure the suspension is relaxed and no bias, or uneven force is being applied to the steering system.
IMPORTANT:
After turning OFF the ignition, allow 25 seconds of wait time before performing any procedures that require the vehicles battery to be disconnected, or module memory loss may occur.