LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2005 >> G6 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Cruise Control System) >> Repair Instructions >> Cruise Control Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Steering Wheel Components
    GM1539232Courtesy of GENERAL MOTORS CORP.
  1. Install the cruise control switch (1).
  2. Install the steering wheel trim cover (3).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the cruise control switch screws (2).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  4. Install the steering wheel rear trim cover screws (4).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    5. Fig 2: Identifying Steering Wheel Electrical Harness Grounding Screw
    GM1539231Courtesy of GENERAL MOTORS CORP.
  5. Install the steering wheel electrical harness grounding screw (1).

    Tighten:  Tighten the screw to 6 N.m (53 lb in).

  6. Attach the electrical harness connector retainer clip (2) to the steering wheel trim cover.
  7. Install the steering wheel to the vehicle. Refer to Steering Wheel Replacement in Steering Wheel and Column.
scientia non olet · About LEMON Manuals