LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> G6 L4-2.4L >> Repair and Diagnosis >> Heating and Air Conditioning >> Testing and Inspection >> Scan Tool Testing and Procedures >> HVAC - Automatic >> Scan Tool Data Definitions
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Scan Tool Data Definitions



Scan Tool Data Definitions

A/C Disengage History 1, 2, 3, or 4
- The scan tool displays one of the following reasons why the powertrain control module (PCM) or engine control module (ECM) has disengaged the A/C compressor; None, System Voltage, Wide Open Throttle WOT, CKP, Learn Active, Engine Run Time, Coolant Hot, Anti Stall, A/C Pressure, Engine Speed, Trans Engine Speed, A/C Pressure Sensor, Low Voltage, High Voltage, Outside Air, Temp, RPM unstable, Launch Performance, A/C Switched Off.

A/C High Side Pressure Sensor
- The scan tool displays 0-3450 kPa (0-500 psi). The voltage applied to the PCM or ECM input from the A/C refrigerant pressure sensor is converted to a pressure value.

A/C High Side Pressure Sensor
- The scan tool displays 0-5 volts. The voltage applied to the PCM or ECM input for the A/C refrigerant pressure sensor.

A/C Off for WOT
- The scan tool displays the high throttle disable of the A/C compressor.

A/C Pressure Disable
- The scan tool displays the status of the A/C high side pressure sensor. The scan tool displays Active/Inactive.

A/C Relay Command
- The scan tool displays On/Off. The scan tool displays the control decision for the compressor clutch relay output as determined by the PCM or ECM.

A/C Relay Circuit History
- The scan tool displays the following message stating the history status of the A/C relay control circuit. The scan tool displays OK/Open/Short.

A/C Relay Circuit Status
- The scan tool displays the following message stating the circuit status of the A/C relay control circuit. The scan tool displays OK/Fault.

A/C Request Signal
- The scan tool displays Yes/No. The scan tool displays Yes when the PCM or ECM receives a message to engage the A/C compressor clutch. The scan tool displays No when the PCM or ECM receives a message to disengage the A/C compressor clutch.

A/C Request Switch
- The scan tool displays On/Off. The A/C request switch shows current status of the A/C request switch function on the body control module (BCM).

ECT Sensor
- The scan tool displays -40 to +215°C (-40 to +419°F). The voltage applied to the PCM or ECM input from the engine coolant temperature sensor is converted to a temperature value.

Ignition 1 Signal
- The scan tool shows available voltage at the PCM or ECM. The scan tool displays 0-12 volts.
scientia non olet · About LEMON Manuals