LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> G6 L4-2.4L >> Repair and Diagnosis >> Starting and Charging >> Testing and Inspection >> Scan Tool Testing and Procedures >> Scan Tool Data Definitions
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Scan Tool Data Definitions



Scan Tool Data Definitions

Battery Voltage
- The scan tool displays 0-20 volts. The scan tool displays the voltage as received by the module or the 72-08 battery voltage message from the body control module (BCM).

Battery Voltage Signal
- The scan tool displays 0-20 volts. The scan tool displays the voltage as received by the module or the 72-08 battery voltage message from the BCM.

Crank Request Signal
- The scan tool displays Yes or No. The scan tool displays No until the ignition is placed into the START position then Yes is displayed.

GEN F-Terminal Signal
- The scan tool displays 0-100 percent. The scan tool displays the percentage of the field current.

GEN L-Terminal Circuit Status
- The scan tool displays Fault, Indeterminate or OK. The scan tool displays the status of the GEN L-Terminal circuit.

GEN L-Terminal Circuit Status
- The scan tool displays Incomplete, Short, GND/Open, Short to B+ or OK. The scan tool displays the status of the GEN L-Terminal circuit.

GEN L-Terminal Command
- The scan tool displays 0-100 percent. The scan tool displays the percentage of the GEN L-terminal signal.

GEN L-Terminal Signal Command
- The scan tool displays On or Off. The scan tool displays the status of the GEN L-terminal signal.

Ignition 1 Signal
- The scan tool displays 0-20 volts. The scan tool displays the voltage as received on the Ignition 1 circuit to the ECM/PCM.

Power Mode
- The scan tool displays Off, Accessory, Run and Crank Request. The scan tool displays the state of the ignition switch.

Run/Crank Relay
- The scan tool displays On or Off. The scan tool displays the actual state of the Run/Crank relay. It will display On when in a remote start event.

Run/Crank Relay Command
- The scan tool displays On or Off. The scan tool displays the commanded state of the Run/Crank relay.

Starter Relay Circuit Status
- The scan tool displays Incomplete, Short, GND/Open, Short to B+ or OK. The scan tool displays the status of the starter relay circuit.

Starter Relay Command
- The scan tool displays On or Off. The scan tool displays Off until engine start has been requested, then it reads On.
scientia non olet · About LEMON Manuals