Installation Procedure

Fig 1: Removing/Installing Turn Signal Switch Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

NOTE: Refer to Fastener Notice .

Secure by using 2 pan head tapping screws.
Tighten: Tighten the screws on the top and front of the column to 1 N.m(9 lb in).
Connect the connectors to the turn signal and multifunction switch assembly.
Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .