Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying O-Ring Seals

Courtesy of GENERAL MOTORS CORP.

Install the 12 EBCM O-ring seals (1).
If installing a new EBCM, install new O-ring seals.

Fig 2: View Of EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

Carefully install the EBCM (1) to the BPMV.

NOTE: Refer to Fastener Notice .

Fig 3: Identifying Electronic Brake Control Module

Courtesy of GENERAL MOTORS CORP.

Install the EBCM bolts (1).
Tighten: Tighten the bolts to 3 N.m (27 lb in).
Connect the electrical connector to the EBCM.
Install the cover to the ECM and TCM.
If a new EBCM is being installed, program the EBCM. Refer to Electronic Brake Control Module Programming and Setup .
Refer to Control Module References for programming and setup information.