LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Torrent FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Rear Suspension System) >> Repair Instructions >> Support Rear Drive Module Mounting Bushing Replacement >> Removal Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the production muffler and resonator as an assembly. Refer to Exhaust System Replacement in Engine Exhaust.
  3. Remove the rear stabilizer shaft. Refer to Stabilizer Shaft Replacement .
    4. Fig 1: Removing/Installing RDM Rear Mounting Bracket
    GM929547Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear drive module bracket to support bolt and nut. Discard the nut.
  5. Remove the rear drive module to rear drive module bolts and nuts. Discard the nuts.
  6. Remove the rear drive module bracket from the vehicle.
    7. Fig 2: Installing Bolt & Washer Through The Driver, Bushing, & Receiver
    GM932554Courtesy of GENERAL MOTORS CORP.
  7. Install the J 44866  to the support assembly in the following procedure.
    1. Position the large part of the tool over the bushing flange and against the frame.
    2. Install the bolt and washer.
    3. Install the small part of the tool against the bushing.
    4. Lube the threads of the J 44866  with extreme pressure (EP) lube.
      5. IMPORTANT: Ensure the small end of the tool is aligned with the bushing.
    5. Install the bearing, washer and nut.
    6. Tighten the J 44866  in order to remove the bushing from the support assembly.
scientia non olet · About LEMON Manuals