LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2007 >> Torrent FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Rear Suspension System) >> Repair Instructions >> Support Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Body Bolts & Support Assembly
    GM930332Courtesy of GENERAL MOTORS CORP.
  1. Position the support assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the support to body bolts.

    Tighten:  Tighten the support to body bolts to 170 N.m (125 lb ft).

  3. Connect the toe link to the support assembly. Refer to Toe Link Replacement .
  4. Connect the upper control arm to the support assembly. Refer to Rear Axle Upper Control Arm Replacement .
  5. Install the lower control arm to the support assembly. Refer to Rear Axle Lower Control Arm Bushing Replacement .
  6. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement .
  7. If equipped with all wheel drive, install the rear drive axle. Refer to Differential Replacement in Rear Drive Axle.
    8. Fig 2: Removing/Installing Intermediate Pipe & Muffler Assembly
    GM926831Courtesy of GENERAL MOTORS CORP.
  8. Install the exhaust muffler and resonator assembly. Refer to Exhaust System Replacement in Engine Exhaust.
  9. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
  11. Check the rear alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals