Component Testing
CAUTION:
Refer to SIR Caution
.
- Ignition OFF, disconnect the harness connector at the suspect switch.
- Test the right switch for 2360-2400 ohms of resistance between both remote radio control supply voltage terminals 2 and 5 with the switch in the open position.
- If the resistance is not between 2360-2400 ohms of resistance, replace the right switch.
- Test for infinite resistance between the supply voltage terminal 5 or terminal 4 and the signal terminal 1 with the switch in the open position.
- If less than infinite resistance, replace the switch.
- Test resistance values between the supply voltage terminal 5 or terminal 4 and the signal terminal 1 with the switch closed in each position and verify readings are approximate to what the schematic reads.
- If the values do not match, replace the switch.