Brake Pressure Modulator Valve Bracket Replacement

Fig 1: View Of Brake Pressure Modulator Valve Bracket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Place the ignition switch in the OFF position. Remove the underhood electrical center bracket. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
1	Brake Modulator Assembly Bracket Bolt NOTE: Refer to Fastener Notice . Tighten: 20 N.m (15 lb ft)
2	Brake Modulator Assembly Bracket Nut (Qty: 2) Tighten: 10 N.m (89 lb in)
3	Brake Modulator Assembly Bracket Tip: Without disconnecting the brake pipe fittings, carefully remove and support the brake modulator assembly.